BUYER GUIDE / PIVOT DOOR HARDWARE
Pivot door hardware service access.
What should stay reachable?
Plan access to the pivot, closer and replacement parts before the floor and ceiling are finished.
By Asvnt-Door · Published
THE BUYING DECISION
Draw the service route
before finishing.
Two pivot doors can look alike while giving a technician very different access to their hardware. Ask what can be inspected with the leaf in place, what requires a qualified crew to remove it, and which finishes would need to be reinstated. Resolve those points before approving the door and floor drawings.
01 / HARDWARE LAYOUT
Find the hardware on the drawing.
Ask the supplier to show the upper pivot, lower pivot and closing mechanism on the approved section. In one arrangement the mechanism is in the leaf and connects to floor and head plates, as illustrated by the FritsJurgens System M+ documentation. In another, the closer is recessed in the floor, as illustrated in the dormakaba BTS 80 technical folder. These are layout examples, not components included in an Asvnt-Door quote.
02 / FINISH COORDINATION
Mark what must stay accessible.
Before the floor and ceiling details are frozen, ask the installer to mark which service points are accessible with the door in place and which need the leaf removed. Check that a stone border, mat recess or ceiling trim will not obstruct the specified access. If there is a floor cover, ask the flooring contractor and door installer to agree what stays removable and who makes good the finish after work.
For an exterior entrance, coordinate the access detail with the threshold, drainage and seal design rather than leaving a cutout to be resolved on site. Our exterior pivot door seal guide covers what to ask about those interfaces.
03 / HANDOVER
Request a record someone can use later.
| Request | Check before accepting |
|---|---|
| Hardware schedule | Actual maker, model and part references for the upper and lower assemblies and any separate closer. |
| As-built detail | Final floor and head sections, removable covers, and whether service or replacement requires leaf removal. |
| Care and spares | Manufacturer instructions for the supplied model, inspection scope and how to order compatible parts. |
| Service responsibility | Who inspects a fault, moves the leaf safely and reinstates seals or finishes after work. |
Keep the final drawing revision and model references together. An appearance photo or the words “concealed pivot” are not enough to identify a replacement.
04 / REPLACING A PART
Confirm compatibility before ordering.
Ask the supplier to confirm the replacement against the installed model, leaf details, pivot position, plates and closing requirements. Similar-looking hardware does not establish a fit. If a substitute is proposed, ask for the changes to the assembly and finish interfaces in writing before approving it.
Heavy leaves and hardware under load should be assessed by a qualified installer. This guide is a procurement checklist, not instructions to loosen a pivot, remove a leaf or adjust its closing action.
BUYER QUESTIONS
Before you order.
Does every pivot door need a floor access cover?
No. Confirm the quoted hardware arrangement and its actual service requirements before agreeing the floor detail.
Can I identify a replacement from a photo?
Use the photo as supporting context. Request the installed model and part reference, then have the supplier confirm compatibility.
Who should check a door that rubs or closes differently?
Ask the installer or hardware service provider to inspect it against the installed system’s instructions. Do not assume the closer is the only cause.
PREPARE YOUR ENQUIRY
Send the opening section.
Mark the finishes.
Share the door reference, floor and ceiling details and the access constraints you want covered in the quote.
Discuss your pivot door
